A Non-Intrusive Way of Bringing Cables Into an RV

All of last summer, winter, and spring, I brought my internet antenna cable in through the office window, sealing the gap as best as I could with tape and, in the coldest month, towels. Bugs and cold still managed to get in. This summer, I was determined to find a better, yet non-intrusive, way to bring cables into my RV.

My impetus was moving to a new type of cellular booster. I’m not ready to blog about that as my system is not working as well as expected and I’m still exploring other options. So while I wanted to bring the cable in in such a way that bugs and cold couldn’t get in, I didn’t want to make any holes since I’m not sure my booster system is what I’m going to end up using permanently here.

If I ever get this booster working as well as I believed it would, I will likely put a hole in the roof over a cabinet, install the booster in there, and run the cable to it. But for now, the cable is out of my way and this is working out well.

My coax cable is in two sections, with its connector being at ground level. So when I had to move Miranda in a hurry a few weeks ago, I was able to show Caroline where the junction was and leave her to disconnect the two bits and coiling the part attached to the RV around the ladder while I did other things instead of my having to disconnect the booster from inside and scramble onto the roof to yank the wire out of the way. Unintentional, but perfect, design!

2 thoughts on “A Non-Intrusive Way of Bringing Cables Into an RV

  1. Those vent covers are designed to leave a gap between the cover and the roof. This is to prevent water buildup inside the cover which would lead to damage to the roof.

Leave a Reply

Your email address will not be published. Required fields are marked *